![]() The Clone Source panel provides an option to save up to five different sample points. Choose Window > Clone Source or click the Clone Source panel icon in the options bar to show it. ![]() The Clone Source panel is not visible by default. Once they’re set, painting with the Clone Stamp tool applies these settings for the active clone source. ![]() With a clone source captured in the Clone Source panel, you can adjust additional settings, such as angle and size. For example, you might want to reduce the size of the clone source you paint with so that the cloned pixels better match that part of the image you are fixing. There may be times when it would be beneficial to have more control over the Clone Stamp tool. With the Clone Stamp tool, every time a new sample is taken the previous sample is replaced. Notice that the sampled area is visible inside the brush, allowing for precise placement of copied material.Ĭonsider reducing the Clone Stamp tool’s Opacity setting in the options bar so that the touchups blend in better with their surroundings. Move your cursor to the spot to be removed and click again. Click to sample that area, and release the key ( FIGURE 5.39). The cursor will take the appearance of a target. Move the cursor to an area that would be a good replacement for where the spot is. Hard-edged brushes generally will leave visible unnatural lines in the image, giving the appearance of a finger running through wet paint. Wayne prefers a brush with the hardness set to 0. ![]() Sampling from the same spot repeatedly may create an unnatural-looking pattern.Ĭhoose a brush size slightly larger than the spot to be removed. Select Aligned in the options bar so that the cursor doesn’t always sample from the same area, which is the best choice for most pictures. With the Aligned option selected, the sampling point will keep relocating, moving in tandem to the position of the cursor. With the Aligned option unselected, the Clone Stamp tool will repeatedly pull information from the same sampled point. ![]() The Clone Stamp tool has two options for where it pulls its sampling point from: aligned and nonaligned. This will place all cloning onto the new layer and keep the Background layer untouched. Create a new empty layer on top of the Background layer for nondestructive cloning.Ĭhoose the Clone Stamp tool from the Tools panel, and in the options bar select Current & Below from the Sample menu. FIGURE 5.38 This typical old image shows some minor dust spots. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |